Decoderpro9/6/2023 This does not necessarily mean that the values have notīeen written, just that the program has not received an acknowledgement. Instances the system will "time-out" after a certain number of tries without anĪcknowledgement from the decoder. Software will automatically keep trying until the write operation is successful. If there is difficulty writing to the decoder, the data will change to red. As the write operation proceeds, the data will change from yellow to Writing usually takes much less time than reading, because the valueĬan be sent directly. When you are finished, click on Write full sheet That the address type agrees with the number of characters in the address. To turn on or off 4 digit addressing, select the desired radio button. If you wish to change the address of the locomotive, type in the To read CVs, then these buttons will not be available. If your system does not have the capability "idle") you will see a running account of exactly what DecoderPro is doing, for example, theįunctions are dependent on your command station. At the very bottom of the pane (where it says Once again,ĭecoderPro must play "Twenty Questions" to get this information, and sometimes even has toīe patient, especially with older computers. Turn white once the values have been read successfully from the decoder. Settings will turn red while they are in the process of being read (clever, eh?), and will Installed decoder will allow readback of decoder values), click on the Read full sheet button. To read the actual settings for these options (and IF your system and Written back to the decoder appear in a orange color. Settings that have been changed by the user and have not been The yellow highlighting indicates these options are "probable" settings and have not beenĬonfirmed from the decoder. Select the appropriate entry from the drop-down list. To enable Analog (old style DC, some vendors refer to this as dual mode) Operation How do I set up to program a decoder? DecoderPro Programming Modes.How do I set up my Preferences? Using DecoderPro.How do I start DecoderPro® program for the First Time User?.What DCC systems will DecoderPro work with?.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |